Please follow these simple steps and you should be good:
- Plug in the power cable to the power source.
- Press the Reset button. Make sure the RED indicator turns on. DO NOT press the TEST button, which will switch off the power actually.
3. Wait for 5 sec. This is the time taken for initial charge up. Therefore, after switching on the power source, please wait for atleast 5 sec before tapping the power button from Rotimatic.
4. Check if there is red light through the side vents.
- In case there is no red light, when seen through the side vents, please make sure the power cable is properly inserted as shown below:
- If there is RED light seen through the side vents , and the power button is not responding, please let us know. We will be happy to assist you further.